Weapon Handler issue

[batman]

I followed the tutorial exactly as the youtube video says but it does not show the scabbard on the character when I equip the weapon or both the sword and scabbard when I unequipped the weapon. The character will go through the equip animation and hold the weapon. The sword is in my starting inventory and I have watched and followed the video a dozen times. Has anything changed over the last few years since the video was made?

[Invector]

The only change we did in the WeaponHolder is that now you can assign an Equip animation and an Unequipped animation instead of using the same clip, we also add a delay for each animation so you can better sync, other than that you just need to make sure the EquipPointName and ID's are correct

[batman]

I took the prefab sword/scabbard that I used to make the actual weapon out of and the character does equip and unequipped the weapon but the scabbard does not show on his back when it is equipped/unequipped. I have tried it over and over with different fbx models as well and I cannot figure out what is different. What screenshots can I send to try and help me figure this out.

[Invector]

The EquipPointName should be "LeftArm" or "RightArm" as it is in your ItemManager



Instead you type "BastardSwordHolder"